American Bladesmith Society Forum: Ats34 - American Bladesmith Society Forum

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Ats34 Salt pot heat treating

#1 User is offline   Paul Piccola 

  • Forum Member
  • PipPip
  • View gallery
  • Group: Members
  • Posts: 6
  • Joined: 29-May 10
  • LocationHughes Springs, Texas
  • ABS Rating:Apprentice Smith

Posted 26 September 2011 - 02:03 PM

I am working on two very thin filet knives. I need to have them heat treated via salt pots.
Can anyone recommend someone who does this? Thanks!
Benjamin Paul Piccola
http://www.piccolaknives.com
http://www.lopiccoloforge.com
GHS Class of 65
0

#2 User is offline   Dale Huckabee 

  • Advanced Forum Member
  • PipPipPipPip
  • View gallery
  • Group: Members
  • Posts: 121
  • Joined: 31-May 10
  • LocationMaylene, Alabama
  • ABS Rating:Journeyman Smith

Posted 26 September 2011 - 02:54 PM

I don't know about using salt pots, but I have always used Paul Bos to heat treat any ATS34 that I've used. Sorry, I don't have his address handy.

Dale
Dale Huckabee
Journeyman Smith
dalehuckabeeknives.weebly.com
0

#3 User is offline   Paul Piccola 

  • Forum Member
  • PipPip
  • View gallery
  • Group: Members
  • Posts: 6
  • Joined: 29-May 10
  • LocationHughes Springs, Texas
  • ABS Rating:Apprentice Smith

Posted 28 September 2011 - 12:37 PM

View PostDale Huckabee, on 26 September 2011 - 03:54 PM, said:

I don't know about using salt pots, but I have always used Paul Bos to heat treat any ATS34 that I've used. Sorry, I don't have his address handy.

Dale

Thanks Dale! I found him and sent a email!
Thanks again!
Benjamin Paul Piccola
http://www.piccolaknives.com
http://www.lopiccoloforge.com
GHS Class of 65
0
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users