American Bladesmith Society Forum: W2 At Tremebley Tool Steel - American Bladesmith Society Forum

Jump to content

The American Bladesmith Society, Inc provides this area for individuals to exchange information between themselves. The ABS does not endorse or recommend any product, tool, supply, manufacturer, company, service, technique or any information or item that may be contained, referenced, or mentioned in this website content or resource associated directly or indirectly with the ABS website.The ABS is not responsible for any damages related to any transactions that occur including but not limited to fraud, defective or damaged merchandise, lost orders, or personal injury. Buy and sell at your own risk.

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

W2 At Tremebley Tool Steel

#1 User is offline   Mike Krall 

  • Advanced Forum Member
  • PipPipPipPip
  • View gallery
  • Group: Members
  • Posts: 78
  • Joined: 06-June 10
  • LocationLander, Wyo.
  • ABS Rating:Apprentice Smith

Posted 01 February 2011 - 09:46 PM

There is a bunch of W2 available at Trembley Tool Steel. ALL of it is in very large sizes... some rectangle, some square, some round, some plate. The smallest pieces were 3/4" x 1" (it's gone) and it jumps up quickly from there. A person is going to have to cut it to use it unless there is a hydraulic presses and/or power hammer available. Even then, this stuff is big.

E-mail Stan Cochrac and ask him for the W2 list and cost. It is very inexpensive... if you can deal with the sizes.

Link here to original post on BS forum and Don Hanson reply... http://forums.dfoggk...showtopic=18957

Mike
As a person insists they have a right to deny others their individual freedoms, they acknowledge those others have the right to deny them theirs...
0
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users